To configure and test a device on the Softruck platform, it must have been previously registered correctly in the tool. If this has not been done yet, you can check our tutorial: How to register a SIM card and device.
With the device properly registered, it needs to be configured to report to the Softruck platform.
In this manual, we will learn how to perform this configuration via text messages (SMS), which should be sent to the number of the SIM card embedded in the respective equipment.
Before starting to send the configuration commands:
Install the SIM card in your device.
Connect the equipment to a 12V power source.
Make sure the device is in an open area to facilitate communication.
Once this is done, send the basic configuration messages to your tracker:
1. Command to configure APN:
0000,109,APN,USUARIO,SENHA
Contact your SIM card provider to find out which APN, username, and password to use.
2. Command to configure IP/Porta:
0000,100,1,18.208.81.112,3690
3. Command to configure communication time:
0000,102,t1,t2,300
T1: seconds with ignition on
T2: seconds with ignition off
Perfect! Just check the device's status in the Softruck tool. If the equipment is not communicating, verify the SIM card, the registered IMEI, and the sent configurations.
Additional commands
Reset Device:
0000,910,3
Block Vehicle:
0000,900,1,1
Unblock Vehicle:
0000,900,1,0
Turn on Sleep Mode:
0000,124,1,300
Turn off Sleep Mode:
0000,124,0,0
Enable Virtual Ignition via Accelerometer:
0000,721,1
Enable Virtual Ignition via Key-On Signal:
0000,721,0
Request Location:
0000,800
Set Odometer (M):
0000,610,valueOdometer
Set Speed Limit:
0000,123,valueSpeed
If you’ve made it this far in our article, we believe you might be interested in speaking with our team of specialists. Click the button below to learn more:
