To configure and test a device on the Softruck platform, it must first be properly registered in the tool.
Once the device is properly registered, you must configure it to report to the Softruck platform.
In this manual, we will learn how to perform this configuration via text messages (SMS), which must be sent to the phone number of the SIM card installed in the respective device.
Before sending the configuration commands:
Insert the SIM card into your device.
Connect the device to a 12V power source.
It is important to note that the APN, username, and password must be updated with the correct information for each, as they vary depending on the SIM card provider and the mobile carrier used.
Once this is done, send the following commands to configure your ST-4315 device.
Configuration commands
Command to configure APN:
PRG;IDENTIFIER;10;00#01;01#APN;02#USER;03#PASSWORD
Command to configure IP, Port:
PRG;IDENTIFIER;10;05#52.87.53.184;06#3675;08#52.87.53.184;09#3675
Configuring Time:
PRG;Id;16;70#STOP TIME;71#0;72#0;73#IGNITION ON, VEHICLE STOPPED;74#0;75#ANGLE;76#0;77#0;78#0;79 #MOVEMENT TIME;80#0;81#ANGLE;82#60; 83#0;84#0;85#60;86#0;87#0
Stopped time (ignition off): 3600
Stopped mode time (ignition on and vehicle stopped): 60
Movement time: 60
Angle: 30
NOTE: The model ID has 10 digits
Done! Just check the device’s online status in the Softruck tool. If the device is not communicating, check the chip, the registered IMEI, and the settings sent.
It is important to note that for the platform to recognize the device, it must be registered correctly.
Additional Commands for the Suntech 4315U
Request ICCID:
CMD;IDENTIFIER;01;03
Request Location:
CMD;IDENTIFIER;03;01
Reboot:
CMD;IDENTIFIER;03;03
Enable output (BLOCK):
CMD;IDENTIFIER;04;01
Disable output (UNLOCK)
CMD;IDENTIFIER;04;02
Hour meter adjustment (max minutes: 99999):
CMD;IDENTIFIER;05;05;valueInMinutes
Odometer adjustment (max meters: 1000000000):
CMD;IDENTIFIER;05;03;valueInMeters
If you’ve made it this far in our article, we believe you might be interested in speaking with our team of experts. Click the button below to learn more:
