Skip to main content
All CollectionsConfiguration manuals (commands)
How to configure the J14 tracker via SMS
How to configure the J14 tracker via SMS

Device Configuration and Testing on the Softruck Platform: Complete Guide to Configuration and Sending Commands via SMS

Updated this week

To configure and test a device on the Softruck platform, it must have been previously registered correctly. If this has not been done yet, you can check our tutorial: How to register a SIM card and device.

With the device properly registered, it needs to be configured to report to the Softruck platform.

In this manual, we will learn how to perform this configuration via text messages (SMS), which should be sent to the number of the SIM card embedded in the respective equipment.

Before starting to send the configuration commands:

  • Install the SIM card in your device.

  • Connect the equipment to a 12V power source.

  • Make sure the device is in an open area to facilitate communication.

Once this is done, send the basic configuration messages to your tracker:

1. Command to configure APN:

APN,apn.com,username,password#
  • Contact your SIM card provider to find out which APN, username, and password to use.

2. Command to configure Ip/Port:

SERVER,0,18.232.201.231,3674,0#

3. Command to configure time zone:

GMT,W,0,0#

4. Command to configure communication time:

TIMER,30,600#

30: seconds with ignition on

600: seconds with ignition off

Perfect! Just check the device's status in the Softruck tool. If the equipment is not communicating, verify the SIM card, the registered IMEI, and the sent configurations.

Additional commands

Reset device:

RESET#

Block vehicle:

RELAY,1#

Unblock vehicle:

RELAY,0#

Check Sleep mode:

CXCS#SLPDISCONNECT

Check localization by link:

WHERE#

Configuration mode for motorcycle:

Activate battery economy:

SZCS#GPS_DISSLP=0

Activate Sleep Mode:

SZCS#SLPDISCONNECT=X

Replace X according to the following parameters:

X=0 Stay connected to the platform.

X=1 Sleep Mode, Disconnects from the platform. SMS works.

X=2 Sleep Mode, Disconnects from the platform. SMS does not work.

If you’ve made it this far in our article, we believe you might be interested in speaking with our team of specialists. Click the button below to learn more:

Did this answer your question?